Measure the distance from baseboard to ceiling line in several different spots around the room. You will probably find that the wall is higher in some spots than others. Make a note of the maximum height.
Add 4 inches to the maximum wall height. This extra 4 inches will give you at least 2 inches extra to work with at both the ceiling line and baseboard (for trimming or for uneven walls).
Use this measurement to cut the first strip of wallpaper and to cut each subsequent marching strip.
Before cutting the first strip, check the position of the pattern at the ceiling line. Hold wallpaper against the wall until you find the best point for a pattern break.
Mark the wallpaper where the strip ends at the ceiling line and baseboard. Remove it to the pasting table or a clean, flat area for cutting.
Remember to add 2 inches to both the top and bottom of the strip before cutting.
Cut the second strip after matching the pattern to the first strip. Mark the top of your strips "T" on the back and number them. After cutting the first two strips, cut and paste just one strip at a time.
Tidak ada komentar:
Posting Komentar